Hydraulic Press Brake

Hydraulic Press Brake

'ANASUYA' presents to you a range of most technically advanced hydraulic press brakes with all latest features as per international standards.

Power Pack Unit

  • The low noise Hydraulic system is designed as per international practices and assembled with internationally reputed make components.
  • Valves are mounted on a specially designed compact manifold block minimising pipings and chances of leakages. The large sized oil reservoir provides adequate cooling.
  • Imported sealing kit prevents scratching of bore in case of seal failure and backup seal offers additional sealing enabling to use machine for sometime at a little pressure drop while awaiting seal replacement, thus avoiding downtime.

Structure

The all steel structure of ANASUYA Press Brakes consist of side frames, ram, I-Beam type table and pair of levers manufactured from ultrasonically tested steel plates. All sections are designed to give minimum deflections and maximum rigidity as per international standards. Pair of hydraulic cylinders are synchronized by a heavy duty torque tube welded to the levers. This offers absolute parallelism between them and table working surfaces.

Other Important Features

  • Repetitive accuracy is with in ± 0.04 mm
  • International Quality hydraulic valves rated at 310 bar but working pressure is less than 160bar, this ensure trouble free operation.
  • Adjustable five piece guides, provided with special non metallic liners for long life.
  • Quick adjustable stroke length.
  • Front operated back gauge with micro setting arrangement
  • Raw tilting arrangements to maintain bending accuracy over a period.
  • Moving work station with on / off buttons, selector switches foe inch, single cycle & auto cycle & emergency stop buttons for easy operation & better safety.
  • Rear Cylinder design using mechanical advantage through lever, reduces the cylinder size which enable to use medium pressure hydraulic component & also improves stroke accuracy.
  • Fast approach & fast return speed for reducing cycle time, slow pressing speed for better stroke control & bend accuracy.

Operations

ANASUYA Press Brakes have three operational modes for operators greater convenience and least fatigue which can be selected from the panel door mounted selector switch.

Inch cycle

This mode is used for setting bed angle depth stroke. The ram movement (up down) can be controlled at any described position from foot switches.

Auto cycles

The cycle (Approach-Pressing-Return) is continuously repeated once this cycle is selected. This mode is useful for continuous repetitive work where stroke length can be adjusted to suit the job and the operators speed and rhythm.

Standard Accessories

  • Main Drive Motor
  • Electric Control Panel with selection of Auto,'INCH' & Single Cycle Auto mode operation
  • Movable work station with foot switch
  • Pair of lifting links
  • Pair of Sheet support
  • Manual back gauge
  • One set suitable five way Die & Punch
  • Centralized lubrication system

Optional Accessories

  • N.C. Operated Stroke control
  • N.C. Operated back gauge & stroke control
  • Sliding sheet support with swing away stoppers
  • Hardened tools & special toolings Anti-deflection unit
  • Hydraulic tool clamping
  • Motorized back gauge with DRO
  • Higher throat depth
  • Anti deflection unit
  • Multiple depth setting arrangement
  • First fill of hydraulic oil