3-Roll Plate Bending Machine

'ANASUYA' presents to you a range of most technically advanced 3-ROLL PLATE BENDING MACHINE with all latest features as per international standards.

Standard Accessories

• Main Drive Motor
• Frame built of laser cut high strength steel, welded, stress relieved and sand blasted.
• Hydraulic pressing system on top roll.
• Hydraulic unit by Rexroth and valves by Aron.
• Screw jeck drop-end.
• Mechanical rolls parallelism.
• Bending rolls assembled on heavy duty SKF bearings.
• Centralized lubrication by means of a hand pump.
• Separate controls on control panel.
• Movable work station with pair of foot switch
• Pair of lifting links
• Safety devices and operating manual according to CE norms

Optional Accessoriest

• Hardened rolls to HRC 54-56
• Automatic rolls parallelism by a micro processor
• Tilting of the bending rolls by means of proportional valves and PLC
• Top roll hydraulic balancing system
• Variable speed
• Section bending tools
• Vertical hydraulic support max. Ø2500 mm/ 98” & max. weight 1600 Kg/ 3530 lbs
• N.C. Operated Stroke control
• First fill of hydraulic oil

Bending Operations

• The Plate can be bent on machine by hammering as shown if the thickness of the plate is half than capacity. Thicker plates should be prevent out side the machine.
• Place the Plate between bottom and top rolls by adjusting top roll manually.
• Down the top roll and given pressure on the plate. Then start Main motor in clock wise direction till one end of the plate comes over first bottom roll Reverse the Motors and get second end on second bottom.
• Continue above process until you et desired shall as shown in picture